During the centrifugation process, the operator must not leave the centrifuge room. After use, you must register and indicate the use. It will also be a safety hazard. After tightening the rotor cover, be sure to touch your finger to see that there is no gap between the rotor and the cover. 5. 1. And wipe the remaining water in the cavity, the centrifuge cover should be opened. This process cannot be ignored because of the hurry.

When the rotor is pre-cooled, the rotor cover can be placed on the platform of the centrifuge, or placed on the experimental table, and it must not be tightened and floated on the rotor. 2. OK key to confirm. c) Select the rotor setting item, then use the plus and minus keys to set the rotor type, and press the OK key to confirm. Generally, unplug the power cord after shutdown. four. Once the centrifuge is found to be abnormal (such as imbalance causing the machine to vibrate significantly, or noisy), you should Immediately press the stop button to stop centrifugation. When the centrifuge is in the pre-cooling state, pre-cooling is very necessary. For more information

During the centrifugation process, the operator should not leave the centrifuge room. Machine failures occur during the use of the instrument, and you should contact us in time when the parts are damaged., Ltd. 4. The balanced centrifuge tube should be placed symmetrically in the rotor, and then the rotor cover should be closed and the screws should be tightened. Liquid residue, keep cryo tubes the bricks of the centrifuge dry. If it exceeds, it will cause the liquid to overflow easily. 9. If there is a gap, unscrew and re-tighten the centrifuge until the seamless gap is confirmed. 6.

During ultracentrifugation, the liquid must be filled with the centrifuge tube, because vacuum is required during ultracentrifugation, so the deformation of the centrifuge tube must be avoided only when it is full. When the centrifuge is in the pre-cooled state, the centrifuge cover must be closed. In case of poor sealing of the centrifuge tube cover, the liquid cannot be filled up to prevent overflow, which will affect the normal operation of the sensor. Therefore, when using a centrifuge, you must pay attention to the following operations. Select the centrifugal parameters: a) Select the temperature setting item, and then use the plus and minus buttons to set the centrifugal temperature, and the OK button to confirm. The balance error of the centrifuge tube should be within 0.