Paving that has been done using individual elements can be replaced and repaired very easily. Also, all of this can be done invisibly. One-piece constructions like concrete, pattern, and concrete require replacement or repair that may be patched or cut out. Cement or concrete pavers have cement as the primary ingredient. However, concrete contains water, aggregates like sand, water, additives and elements that shall enhance performance. They are made with a concrete dry mix that contains pigments, gravel, sand, and cement. The wet mix gets poured inside a mold. This then gets vibrated to be compressed as concrete. The concrete then is allowed to get cured. The resultant paver can withstand eight thousand pounds in comparison to three thousand pounds.

Maintaining the concrete pavers

The Concrete Pavers Oklahoma City driveways demand little to no maintenance. A hose rinsing and occasional sweeping keep them quite clean enough. If the weeds make it through its surface, then just have them removed as and when they appear. Stains can usually be removed if a concrete cleaner is used. However, one must always check with the recommendations done by the manufacturers. If the frost or roots of the trees damage sections of driveways then the affected pavers can be removed easily. Once the underlying problem is fixed, the driveway can be put back together.

Installation of concrete driveways (Base)

A driveway Paving Oklahoma requires not many steps to be installed. The very first step towards installation is excavating loose soil and grass. Then, a base made of gravel has to be thoroughly compacted. This is followed by a sand layer. Any basic driveway must have six to four inches of gravel and should be topped with an inch of sand. Driveways need handling of heavy vehicles, for which you require twelve to ten inches which is the most recommended. The base is graded also for facilitating water-runoff.

Installation of edging

Once the base has been readied, edging has to be installed along driveway’s sides so that the pavers can be there. They have to be kept snug. For the installation of pavers, they have to be set simply. Later they have to be fitted together tightly. To keep the rows completely straight, string line must be used. These pavers must be cut for fitting the corners and edges, with help of masonry saw.

Compaction of the pavers

When the pavers are fully down, the entire surface has to be compacted with plate compactor so as to set pavers into a base of sand. During the stage of compaction, and may also be swept across so that small cracks are filled. These cracks can be there between pavers, making them all tightened into a more monolithic and rigid structure.

Steer clear from extreme conditions of weather

Summertime has been considered an amazing time for getting any kind of work related to concrete or asphalt. This is because the weather is most suitable when such paving is laid. When the weather is both temperate and dry, the entire thing can properly set. Winters do not present you with such an amazing opportunity.

Source: http://www.articleted.com/article/112864/9494/Things-you-must-know-about-Paving-Oklahoma-driveways-