Log in with Facebook 
Sanitary pads are a crucial item in our modern society However, even the staff who produce them do not have a good understanding of the equipment which makes the sanitary pads. If there's a problem with the electrical components of the sanitary pads machine what can the owner do to fix it?
1. Mouth first, then hands
If you have a problem with pull up pants electrical machinery Don't hurry to fix it to fix it. You should first inquire questions about the causes of the fault as well as the causes of the fault. For equipment that is not familiar it is recommended to know the principle of circuits as well as the structural characteristics first. Then, follow the appropriate rules. Before disassembling, be aware of the purpose and position of the component, as well as the connection method and the relationship to other components of every component.
2. External first then internal
First, you should examine the machine for obvious cracks and flaws as well as learn about its history of maintenance and service life span, etc. After that, check on the interior of the device. Before dismantling, all the issues should be sorted out. The device is only dismantled if it is found to be an internal defect. If not, blind disassembly could result in the device being damaged over time.
3. Mechanical first, then electrical
Once you have confirmed that the mechanical components are free of fault Conduct electrical inspections. In the event of determining the fault in the circuit the instrument for detection is the best tool to determine the location of the fault. Once you have confirmed that there is no fault in the contact and that the circuit is operating properly, the relationship between circuits and the machine must be examined in a specific method to avoid misjudging.
4. Static first, then dynamic
If the sanitary pads system is not turned on examine the condition of the equipment's buttons and contactors, thermal relays and fuses to pinpoint the location of the fault. Power-on test, listen for the sound, take measurements as well as evaluate faults and then carry out any maintenance. For instance, if the motor is not in phase, or if the three-phase voltage cannot be assessed then you must take note of the noise and then measure the voltage of each phase separately prior to taking a decision about which phase is damaged.
5. Clean first, then repair
If your equipment is heavily polluted First, clean the switches, wire points and contact points. Then, examine if the controls keys are in bad condition. A lot of failures are due to dust and conductive dust blocks. These are typically removed after cleaning.
6. Power first, then equipment
The percentage of failure in the power supply is responsible for a significant portion of the equipment that is damaged and repairing your power source first will typically yield twice the results in half the time.
7. General first, then special
The failures caused by the poor quality of assembly parts and other equipment failures usually make up approximately 50% of all common failures. The particular faults in the equipment are usually soft faults that must be identified and monitored by expertise and tools.
8. Peripheral first then internal
Do not rush to replace damaged parts first. take into consideration replacing the damaged components after you've confirmed that the circuit in the peripheral equipment is functioning normally. Read more about pull up pants machine, Visit here: www.aladdintop.com
9. DC first, then AC
During maintenance the static operating point for the DC circuit has to be first checked followed by it is the dynamic operational point that will be checked.
10. Debug after failure
Sanitary pads machines The cost for each pad is expensive. If there's a problem in the electric equipment it needs to be repaired strictly in accordance with guidelines to prevent the expansion of damage and financial damage.
